 |
 |
 |
|
|
|
[Sponsors] | ||||
[ANSYS Meshing] The surface mesh is intersecting or close to intersecting, making it difficult to cre |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 27, 2018, 07:50
|
The surface mesh is intersecting or close to intersecting, making it difficult to cre
|
#1 |
|
New Member
vương công đạt
Join Date: Sep 2018
Location: Hà Nội, Việt Nam
Posts: 6
Rep Power: 7  |
I have a problem:
- When I did nothing, the auto mesh was good. But when I tried face sizing, it shows the message "The surface mesh is intersecting or close to intersecting, making it difficult to create a volume mesh. Please adjust the mesh size or adjust the geometry to fix the problem." I clicked on "Show problematic geometry" then it shows (picture). I do not know how to fix the geometry at that red point. Could some one help me out ?? |
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ANSYS Meshing] Mesh failed error:surface mesh is intersecting or close to intersecting | AdelMahgoub | ANSYS Meshing & Geometry | 2 | May 20, 2019 07:29 |
| [snappyHexMesh] Disturbance in the mesh after the addition of layers | Dorian1504 | OpenFOAM Meshing & Mesh Conversion | 0 | June 13, 2017 02:27 |
| [snappyHexMesh] SnappyHexMesh no layers and no decent mesh for complex geometry | pizzaspinate | OpenFOAM Meshing & Mesh Conversion | 1 | February 25, 2015 07:05 |
| OpenFOAM on MinGW crosscompiler hosted on Linux | allenzhao | OpenFOAM Installation | 127 | January 30, 2009 19:08 |
| DecomposePar links against liblamso0 with OpenMPI | jens_klostermann | OpenFOAM Bugs | 11 | June 28, 2007 17:51 |
Linear Mode
