|
[Sponsors] |
|
November 2, 2020, 06:03 |
Wind Turbine Unstructured meshing
|
#1 |
New Member
endeavor
Join Date: Nov 2020
Posts: 10
Rep Power: 5 |
I am stuck in the surface meshing of the wind turbine blade. I am using patch dependent method but I am not getting the desired mesh. Check the image I am attaching. The tri elements are too elongated.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ANSYS Meshing] How to properly mesh whole wind turbine (structured mesh on curved geometries) | rusham | ANSYS Meshing & Geometry | 3 | February 16, 2020 14:29 |
Meshing wind turbine including tower in AutoGrid | Ko_Shine | Fidelity CFD | 18 | November 13, 2019 08:18 |
Hybrid Meshing for horizontal axis wind turbine | Eslam Hashem | Pointwise & Gridgen | 7 | September 15, 2014 14:52 |
Wind turbine simulation problem | sanchovg2 | STAR-CCM+ | 12 | March 5, 2013 04:18 |
[GAMBIT] Meshing a wind turbine for wing tip vortexes | Grog106 | ANSYS Meshing & Geometry | 1 | March 29, 2012 06:07 |