 |
 |
 |
|
|
|
[Sponsors] | ||||
December 7, 2020, 00:52
|
Mesh has uncovered edges
|
#1 |
|
New Member
Join Date: Nov 2020
Posts: 23
Rep Power: 5  |
Hi,
I have created a mesh for a nozzle, after pre-mesh when I try to convert it into a .msh file, I face the following error: WARNING: Mesh has uncovered faces. Done WARNING: Mesh has uncovered edges. ANSYS Fluent needs a complete boundary (lines in 2D) or it will give a variety of errors and not read in the mesh! If this was 2D Hexa, perhaps your edges are not associated with perimeter curves. I have tried some of the suggestions in similar posts but I'm unable to solve the problem. I'll appreciate your help. |
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] Add Mesh Layers doesnt work on the whole surface | Kryo | OpenFOAM Meshing & Mesh Conversion | 13 | February 17, 2022 07:34 |
| [snappyHexMesh] Snappy Hex Mesh - issue with smoothness of the model edges | olek.warc | OpenFOAM Meshing & Mesh Conversion | 1 | August 31, 2018 11:31 |
| [snappyHexMesh] SnappyHexMesh for internal Flow | vishwa | OpenFOAM Meshing & Mesh Conversion | 24 | June 27, 2016 08:54 |
| Convergence moving mesh | lr103476 | OpenFOAM Running, Solving & CFD | 30 | November 19, 2007 14:09 |
Threaded Mode
