|
[Sponsors] |
[ANSYS Meshing] Apply boundaries with mecanical scripting |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 15, 2021, 09:47 |
Apply boundaries with mecanical scripting
|
#1 |
New Member
Matthieu
Join Date: Oct 2021
Posts: 1
Rep Power: 0 |
Hi everyone, I'm Matthieu and doing my master's thesis in structural engineering.
I'm working on lattice structures. I would like make a lot of simulations in order to have link between geometrical properties and overall structural properties (for example struts diameter to stiffness). It's a lot of simulations. In order to save time, I'm learning about Ansys journal and mechanical scripting. For mechanical scripting, I would like to applie my boundaries (which are the same for all my tests) automatically as i run the script. But for now I don't know how to do it. Their are some region that need a thinner meshing for example. Thanks for any help, that would be precious. Good week end, Matthieu. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Mapped vs Cyclic Boundaries in OpenFOAM | arsenis | OpenFOAM Running, Solving & CFD | 1 | February 8, 2023 21:13 |
Periodic Interface: Symmetry Boundaries are not matching | mazhar16823 | Main CFD Forum | 2 | August 29, 2020 17:30 |
[mesh manipulation] Problem with using createPatchDict to define cyclic boundaries | kaszt | OpenFOAM Meshing & Mesh Conversion | 0 | April 1, 2016 21:18 |
No flow through periodic (cyclic) boundaries in impeller with foam-extend-3.1 | anttiad9000 | OpenFOAM Running, Solving & CFD | 3 | March 2, 2016 19:37 |
2D Rotating Detonation Engine Periodic Boundaries | whitet86 | FLUENT | 2 | June 25, 2015 11:04 |