|
[Sponsors] |
July 6, 2022, 11:54 |
Spacing near the wall
|
#1 |
Member
Mercurial
Join Date: Mar 2021
Posts: 72
Rep Power: 5 |
Hi everyone,
I'm working with DLR F6 Geometry. My mesh is quite fine with high spacing.But when I decrease to very low spacing for y+<5, the elements near the wall become negative volume and be corrupted. I tried to change Projection limit, turn on Project Bspline, some places was fixed but not all. So I want you guys give me some advice to handle this problem Thanks a lot |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Natural convection in a closed domain STILL NEEDING help! | Yr0gErG | FLUENT | 4 | December 2, 2019 00:04 |
Air - Dynamic Viscosity Value, Y+ and wall spacing. | K1650369 | Main CFD Forum | 1 | December 17, 2018 08:11 |
Wrong flow in ratating domain problem | Sanyo | CFX | 17 | August 15, 2015 06:20 |
Very technical question about solving wall boundary layer ... | jlb001 | FLUENT | 6 | December 27, 2014 05:56 |
UDF for wall slipping | HFLUENT | Fluent UDF and Scheme Programming | 0 | April 27, 2011 12:03 |