 |
 |
 |
|
|
|
[Sponsors] | ||||
[ICEM] How two merge two wedge blocks into a quad |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 19, 2023, 11:54
|
How two merge two wedge blocks into a quad
|
#1 |
|
Member
ishan
Join Date: Oct 2017
Posts: 77
Rep Power: 8  |
What is the right procedure to merge two side-by-side wedge blocks into a quad-shaped block in ICEM ? Reference image:
I am trying to make a mesh using the axi-symmetric approach. During rotation of the 2D blocks wedge blocks are created. I eventually want to make an 0Grid but the wedge blocks are preventing me from doing that. I have tried merging the two separate files, one containing 0Grid blocks with the parent file containing remaining blocks. It is giving me issues which I want to avoid. Thank you. |
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Commercial meshers] COnvert FLuent MEsh to openfoam with interface | manuc | OpenFOAM Meshing & Mesh Conversion | 1 | July 25, 2017 03:13 |
| [Commercial meshers] converting Fluent mesh to openfoam standard mesh | deepesh | OpenFOAM Meshing & Mesh Conversion | 31 | March 29, 2017 05:59 |
| dsmcInitialise - dsmcFoam | archymedes | OpenFOAM Pre-Processing | 94 | July 15, 2016 16:14 |
| [blockMesh] How to merge blocks? Match, merge or stitch? | gerritgroot | OpenFOAM Meshing & Mesh Conversion | 0 | November 13, 2015 20:59 |
| [ICEM] Two boxes connected by a cylinder, blocks merge where I don't want them to merge. | Polarbear | ANSYS Meshing & Geometry | 4 | April 30, 2014 15:21 |
Linear Mode
