|
[Sponsors] |
[ICEM] How to create Boundary layer in structured mesh |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
|
May 26, 2023, 13:44 |
How to create Boundary layer in structured mesh
|
#1 |
Member
Join Date: Oct 2022
Posts: 61
Rep Power: 3 |
Dear friends,
I am trying to create boundary layer structured mesh in ICEM. I would like to define specific number of boundary layers. What I understood is that in Pre-Mesh Params > Meshing Parameters, Spacings just determine the height of the first/last cell and using Ratio the height of the adjucent cells of them are determined. But in this part we are not able to define the number of boundary layers. For the rectangular shape below, how can I define a certain number of boundary layers on the upper wall ? Thanks in advance for any help. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] No generation of layer onto zerothickness surface | crubio.abujas | OpenFOAM Meshing & Mesh Conversion | 3 | October 25, 2022 03:20 |
How to set boundary conditions for cylinder+orifice mesh | JD_PM | OpenFOAM Running, Solving & CFD | 0 | March 1, 2022 05:02 |
SHM layer problem on inside mesh | boffin5 | OpenFOAM Running, Solving & CFD | 1 | November 20, 2021 06:26 |
Where's the singularity/mesh flaw? | audrich | FLUENT | 3 | August 4, 2009 01:07 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |