|
[Sponsors] |
February 2, 2024, 10:06 |
Inflation layers on inlet
|
#1 |
New Member
ykj
Join Date: Jul 2023
Posts: 7
Rep Power: 2 |
I have meshed and ran a simulation of a jet into a quiescent fluid. The simulation diverged, and I've gone back to try and improve the mesh. I have some skewed elements close to the inlet patch that have been identified using ICEM check mesh.
Attached is a picture of the circular inlet, and the front wall patch. They are both located at x = 0. I would like to add circular rings/inflation layers around the inlet outer edge because that is where skewed elements were identified. I am hoping that improving the surface mesh will lead to better volume meshing close to the inlet, especially in the shear layers. Any help greatly appreciated. P.S. I am meshing with unstructured elements because this is a simple test case that'll become more complex and require unstructured meshing. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Inflation layers for multiphase flow | Bdew8556 | Main CFD Forum | 0 | April 27, 2022 08:27 |
[Workbench] Problem with inserting inflation layers | cfdfreakSam | ANSYS Meshing & Geometry | 0 | July 21, 2016 01:24 |
dynamic mesh + inflation layers | Albino | FLUENT | 3 | May 15, 2014 13:59 |
[ANSYS Meshing] Inflation Layers around a 90 degree bend that is separated into multiple parts | Kaaji1359 | ANSYS Meshing & Geometry | 2 | August 18, 2013 18:57 |
how to set turbulence model and inflation layers in analysis of an aircraft | realpilot | FLUENT | 2 | April 24, 2013 20:26 |