|
[Sponsors] |
[DesignModeler] How to make the ANSYS Designmodeler capture the intersection point when drawing? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
January 30, 2024, 02:35 |
How to make the ANSYS Designmodeler capture the intersection point when drawing?
|
#1 |
Senior Member
Join Date: Dec 2017
Posts: 387
Rep Power: 9 |
How to make the ANSYS Designmodeler capture the intersection point when drawing?
|
|
January 30, 2024, 06:28 |
|
#2 |
Senior Member
Stuart
Join Date: Jul 2009
Location: Portsmouth, England
Posts: 735
Rep Power: 25 |
It seems you are in the Sketching mode. Use the Construction Point at Intersection in the list of Draw features by clicking on both lines you need the point to be at the intersection.
|
|
February 19, 2024, 22:49 |
Thank you, I have tried it as you said, but it failed, do you have email, would you
|
#3 |
Senior Member
Join Date: Dec 2017
Posts: 387
Rep Power: 9 |
Thank you, I have tried it as you said, but it failed, do you have email, would you please send me a vedio how to do it ? Thank you so much.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
somaFoam - And plasma goes weee | Destouches | OpenFOAM Running, Solving & CFD | 9 | March 14, 2024 18:40 |
Yes, some codes could be better than ANSYS | Dr Youssef Hafez | ANSYS | 0 | January 13, 2023 11:41 |
[Gmsh] Gmsh and samplesurface | touf | OpenFOAM Meshing & Mesh Conversion | 2 | December 10, 2007 02:27 |
PrimitiveMesh intersection point computation | leosding | OpenFOAM Running, Solving & CFD | 2 | August 9, 2005 14:44 |
CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 12, 2001 23:19 |