[la7low]

Hi All!

Does anybody know how to change the direction of an edge (at blocking meshing method)? The direction of edges can be seen when I turn on the bunching on edges or just when I change edge params. I know how to change the direction of a curve, but is there similar command (or sth) that I can do with edges? Actually, a few of my edges are not associated with curves just with surfaces.
I faced this problem when wanted to link buching from other edges to some edges but this problem occured:

'internal error in copy_linked

A minor internal error has occurred.
You may continue to work but if problems arise they may be related to this error.
Try using the check/fix function to fix the problem
The following message was designed to aid developers fix the problem:

can't unlink counts at this point'

I realized that some edges point to the opposite direction than the edge from which I want to copy distribution with link bunching option, so that caused the problem. But still I can not think about other solution than to change edge direction but I do not know how to do it! So anybody please help! Thank You in advance!