|
[Sponsors] |
[ICEM] Problems about meshing the swept wing with cylinder end cap |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 12, 2010, 07:05 |
Problems about meshing the swept wing with cylinder end cap
|
#1 |
New Member
Ke peng
Join Date: Jul 2009
Posts: 19
Rep Power: 16 |
Hi, everyone, I have some prolems about meshing the swept wing with cylinder end cap, wish to get your help, thanks.
As shown in the attachment, i first meshed the 2D airfoil then translate to 3D, , then delete the block inside the wing. but there are two problems, 1) the grid inside the tip face of the wing, where are triagles. 2) the quality of whole mesh is very poor, somes is below 0.0. could someone give me some advice to improve such mesh? Thanks a lot. Last edited by kepeng; May 15, 2010 at 22:51. Reason: add attachment |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2D Low Speed Airfoil Problem when altering Inlet | mike wilson | CFX | 12 | August 3, 2010 11:06 |
monitoring point of total temperature | rogbrito | FLUENT | 0 | June 21, 2009 17:31 |
why the solver reject it? Anyone with experience? | bearcat | CFX | 6 | April 28, 2008 14:08 |
wall velocity not zero | drew | CFX | 2 | July 20, 2007 15:24 |
Please help with flow around car modelling! | Tudor Miron | CFX | 17 | March 19, 2004 19:23 |