|
[Sponsors] |
May 26, 2010, 15:21 |
Null pointer error?
|
#1 |
New Member
Patrick Young
Join Date: May 2010
Posts: 15
Rep Power: 16 |
I'm trying to model a tank, that has a fluid input through one pipe, and a fluid output through another pipe. So to model this, I have created a cylinder for the tank, and attached two smaller cylinders to a face for the inlet/outlets. I where the cylinders touch the tank, I deleted the face of the inlet and outlet pipes, and made a hole in the surface where the inlet/outlets touch the tank.
I then generate the mesh, and that works fine. However, when I open it in fluent, I get the following error: WARNING: cell 15 or thread 22 has NULL face pointer 3. Clearing partially read grid. It also gives me (x,y,z) coordinates of the offending cell, so I looked at where it was, and it appears to be around my outlet. I have attached a picture of the area, and dotted the cell with a green point. Anyone have an idea why this isn't working? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Compile problem | ivanyao | OpenFOAM Running, Solving & CFD | 1 | October 12, 2012 09:31 |
erros when compiling simpleSRFFoam | examosty | OpenFOAM Installation | 12 | April 26, 2010 18:53 |
compile errors of boundary condition "expDirectionMixed" | liying02ts | OpenFOAM Bugs | 2 | February 1, 2010 20:11 |
OpenFOAM on MinGW crosscompiler hosted on Linux | allenzhao | OpenFOAM Installation | 127 | January 30, 2009 19:08 |
DecomposePar links against liblamso0 with OpenMPI | jens_klostermann | OpenFOAM Bugs | 11 | June 28, 2007 17:51 |