 |
 |
 |
|
|
|
[Sponsors] | ||||
January 28, 2011, 10:44
|
parallel mesher error
|
#1 |
|
New Member
Annon
Join Date: Apr 2010
Posts: 18
Rep Power: 16  |
I had cleaned a geometry in ICEM and ran octree mesher (global scaling factor =1 and max global size = 64) the mesh that was created was ~ 35 million tet cells.
But for the same geometry and without changing any other meshing parameters, when I run the same octree mesher in ICEM, it shows that mesh count is ~180 Million. I only changed the no of processors while I created that mesh. Has any one faced this issue before? How can it corrupt the geometry? How to trouble shoot it? Thanks in advance. 
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Compile calcMassFlowC | aurore | OpenFOAM Programming & Development | 13 | March 23, 2018 07:43 |
| Accessing phi from a fvPatchField at same patch | johndeas | OpenFOAM | 1 | September 13, 2010 20:23 |
| Installation OF1.5-dev | ttdtud | OpenFOAM Installation | 46 | May 5, 2009 02:32 |
| How to get the max value of the whole field | waynezw0618 | OpenFOAM Running, Solving & CFD | 4 | June 17, 2008 05:07 |
| Compiling problems with hello worldC | fw407 | OpenFOAM Installation | 21 | January 6, 2008 17:38 |
Threaded Mode
