|
[Sponsors] |
October 6, 2011, 19:32 |
Beginner
|
#1 |
New Member
Join Date: Oct 2011
Posts: 1
Rep Power: 0 |
I want to thank the CFD Online community for accepting me. I would like to share that I am beginning my work on Ansys 12.1 fluent workbench and am looking for some really interactive and fruitful tutorials regarding generating 2d as well as 3d geometries. As I was going through the initial stages, I get stuck at the meshing section "No valid bodies". Kindly share with me information on the same. Once again any help is appreciated.
|
|
October 7, 2011, 01:07 |
|
#2 |
New Member
Join Date: Apr 2011
Posts: 11
Rep Power: 15 |
Could you post screen shots of the problem?
|
|
October 7, 2011, 01:11 |
|
#3 |
New Member
Vikram Singh
Join Date: Oct 2011
Posts: 13
Rep Power: 14 |
Start with the tutorials provided by Cornell. https://confluence.cornell.edu/displ...arning+Modules
Also you should probably start reading this: http://jullio.pe.kr/fluent6.1/help/html/ug/node7.htm This will help you in deciding what kind of model to use for turbulence, what type of solver to use and other aspects during your simulation. Also focus on meshing. Grid generation is one of the most important aspects of cfd, trust me on this, if your mesh is not right, you could get stuck on a problem for days. |
|
October 9, 2011, 23:39 |
|
#4 |
New Member
Tristan Devadason
Join Date: Oct 2011
Posts: 1
Rep Power: 0 |
Hi,
can anyone teach me how to create the geometry for a 2-D lid driven cavity in ANSYS 12.1? Please and thanks. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
beginner in adaptive mesh refinement | aki_yafuji | OpenFOAM Running, Solving & CFD | 13 | May 7, 2020 03:49 |
[snappyHexMesh] meshing with snappy: im a very beginner | samiam1000 | OpenFOAM Meshing & Mesh Conversion | 37 | November 29, 2011 04:51 |
SIMPLE Algorithm - Questions from a Beginner | Emre Turkoz | Main CFD Forum | 8 | August 13, 2010 00:21 |
Beginner | marymasod | FLUENT | 1 | June 3, 2010 16:51 |
[snappyHexMesh] snappyHexMesh beginner problems | sErik | OpenFOAM Meshing & Mesh Conversion | 1 | November 16, 2009 08:47 |