|
[Sponsors] |
[ICEM] Using Blocking with ICEM (infinity lines appear) |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 11, 2011, 21:44 |
Using Blocking with ICEM (infinity lines appear)
|
#1 |
Member
Guiliguili
Join Date: Aug 2010
Location: Montréal
Posts: 97
Rep Power: 15 |
Hello,
I am trying to mesh with ICEM a domain of a flow over a backward facing step but it doesn't work using Blocking. When I use Blocking my 2D domain is not closed. The upper and lower blocking lines continue on the right and left sides to infinity ??? The simple geometry is below. I think that it is an environment setting problem but I don't know which one. Any suggestions. Last edited by Touré; October 13, 2011 at 15:17. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Using Blocking with ICEM (infinite blocking lines appeared) | Touré | ANSYS Meshing & Geometry | 2 | August 5, 2012 17:27 |
[ICEM] ICEM surface trim and blocking projection | Felipe Mendes | ANSYS Meshing & Geometry | 3 | May 21, 2012 03:08 |
Ansys ICEM 12.0 Searching for tutorial information on complex 3d blocking | Raoul | ANSYS | 1 | October 18, 2010 06:08 |
surface flow lines in ICEM postprocessing | Dimitri | CFX | 0 | July 18, 2007 11:30 |
ICEM Blocking 2D and Fluent error | Dr. Flow Squad | FLUENT | 3 | March 5, 2007 02:27 |