|
[Sponsors] |
September 7, 2014, 04:00 |
Ansys workbench Meshing
|
#1 |
Member
|
Hi all, I am trying to do meshing on Ansys workbench 14.5. My geometry comprises of three regions upstream duct, rotating region with blades and downstream duct. I am using hex dominant method for rotating region and mutlizone with mapped mesh type of hexa and free mesh type of hexa dominant. but I am getting very high value of skewness and i want to improve it. can someone help me how can I improve skewness in Ansys workbench?
|
|
September 10, 2014, 07:52 |
|
#2 |
Member
Virendrasingh Pawar
Join Date: Jun 2013
Posts: 47
Rep Power: 12 |
If you want avg. quality mesh, use tetra scheme...if you want to go for hexa switch to icem-cfd (structured block mesh)..ansys default mesh produces poor quality hexa mesh for complex cases (my experience). Good luck!
|
|
September 24, 2014, 01:29 |
Hi
|
#3 |
New Member
rahul kumar
Join Date: Jun 2014
Posts: 24
Rep Power: 11 |
I agree with virendra but you can use local variables such as inflation , edge sizing, contact sizing to improve your mesh quality and skewness
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Strange ANSYS Meshing 13.0 Problem | brunob | ANSYS Meshing & Geometry | 3 | June 21, 2011 20:03 |
[ANSYS Meshing] Migrating from GAMBIT to ANSYS Meshing | David-CFD | ANSYS Meshing & Geometry | 1 | April 1, 2011 05:22 |
Ansys workbench problem | Jonny6001 | ANSYS | 2 | September 30, 2010 12:59 |