the error in System Coupling

newnew · January 24, 2016, 23:59

I'm using System Coupling to perform FSI. At first, all is OK. However, the error occued after I came to my office in the next morning.

Error: Could not connect to System Coupling Service on 49626@XXX.
Error Object: #f

How to correct this erreor? Thanks

Svensen · January 26, 2016, 01:16

Check if firewall enabled.

newnew · January 28, 2016, 22:12

Quote:

Originally Posted by Svensen

Check if firewall enabled.

Thanks. Next time I shall do so. In fact, it recovers by itseflf today without any modification to teh system configuration. Maybe it was tired.

mrkmrk · February 26, 2022, 20:08

Hi Everyone,

I have exactly the same problem. However, the problem still persists even after disabling the firewall.

The error message: "(DP 0) Could not connect to System Coupling Service on 3333@DESKTOP-23PQV01."

In my case, this problem happens when I increase the number of cores on the structural side to more than 2 using the "My computer, Background" parallel processing setting.

January 24, 2016, 23:59	the error in System Coupling	#1
newnew New Member Cap Join Date: Jan 2016 Posts: 5 Rep Power: 10	I'm using System Coupling to perform FSI. At first, all is OK. However, the error occued after I came to my office in the next morning. Error: Could not connect to System Coupling Service on 49626@XXX. Error Object: #f How to correct this erreor? Thanks

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Remeshing_ ANSYS 14.0_ System Coupling	acdesa	ANSYS	4	November 2, 2016 09:12
System coupling problem	Sony	FLUENT	0	September 17, 2013 20:51
System Coupling Expert Settings Related Mapping	SonyCFD	FLUENT	2	August 6, 2013 19:49
Restarting batch job of system coupling in ANSYS14	bbhv	ANSYS	0	June 25, 2012 08:30
System Coupling in ANSYS 14	bbhv	FLUENT	2	March 12, 2012 18:48

January 26, 2016, 01:16		#2
Svensen Senior Member Join Date: Jan 2015 Posts: 150 Rep Power: 11	Check if firewall enabled.

February 26, 2022, 20:08		#4
mrkmrk Member David Join Date: Aug 2013 Posts: 72 Rep Power: 12	Hi Everyone, I have exactly the same problem. However, the problem still persists even after disabling the firewall. The error message: "(DP 0) Could not connect to System Coupling Service on 3333@DESKTOP-23PQV01." In my case, this problem happens when I increase the number of cores on the structural side to more than 2 using the "My computer, Background" parallel processing setting.