|
[Sponsors] |
The value of first cell thickness near the wall (spacing 1 ..in ICEM) ? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
|
December 31, 2016, 03:50 |
The value of first cell thickness near the wall (spacing 1 ..in ICEM) ?
|
#1 |
New Member
Rahul Ohlan
Join Date: Dec 2016
Posts: 5
Rep Power: 9 |
Hello
I've been trying to model the sand-water slurry flow a horizontal cylindrical pipe using the eulerian multiphase model. I'm using ICEM for meshing and all is fine, m using the spacing 1 as 0.5 mm and ratio 1 as 1.2...for refining the mesh at the wall But my solution is not getting converged even after 12000 iterations Any help what could hv been wrong ? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Eulerin wall film model problem about film thickness | ss890527 | FLUENT | 1 | April 18, 2017 10:29 |
[snappyHexMesh] snappyhexmesh cell splitted ununiform..2D case | sharonyue | OpenFOAM Meshing & Mesh Conversion | 1 | April 22, 2013 23:34 |
[ICEM] Export ICEM mesh to Gambit / Fluent | romekr | ANSYS Meshing & Geometry | 1 | November 26, 2011 12:11 |
Wall coordinates and boundary layer thickness | bentmol | Main CFD Forum | 1 | July 3, 2011 20:44 |
Warning 097- | AB | Siemens | 6 | November 15, 2004 04:41 |