|
[Sponsors] |
How to set different periodic conditions for different faces? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
January 6, 2017, 18:55 |
How to set different periodic conditions for different faces?
|
#1 |
New Member
victor
Join Date: Nov 2016
Posts: 2
Rep Power: 0 |
ANSYS workbench v17.2
I have a 3D geometry of a tube and shell heat exchanger with this inlet/outlet face: There is any way to make periodic conditions for each of the faces with different values of bulk temperature, velocity, etc? It is very important for me to do it with the "periodic condition" Thank you very much! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
decomposePar -allRegions | stru | OpenFOAM Pre-Processing | 2 | August 25, 2015 03:58 |
[Gmsh] Vertex numbering is dense | KateEisenhower | OpenFOAM Meshing & Mesh Conversion | 7 | August 3, 2015 10:49 |
Compressor Simulation using rhoPimpleDyMFoam | Jetfire | OpenFOAM Running, Solving & CFD | 107 | December 9, 2014 13:38 |
How to set periodic boundaries with initial conditions? | jiandai | OpenFOAM | 6 | October 24, 2013 07:00 |
DecomposePar unequal number of shared faces | maka | OpenFOAM Pre-Processing | 6 | August 12, 2010 09:01 |