|
[Sponsors] |
February 13, 2017, 10:49 |
Poor mesh quality
|
#1 |
New Member
Pallabi Gogoi
Join Date: Sep 2016
Posts: 4
Rep Power: 10 |
Hello guys
I am doing simulation of forced convection through a rib-grooved square duct (turbulent flow). So i wanted to use inflation layers on the walls...but as soon as i introduced inflation, my mesh quality gets deteriorated...before using inflation, my skewness was .56.....but after inflation the skewness becomes 1...so can you plz tell how to mesh my duct to get better quality using inflation layers? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Unexplained changes of mesh quality and blocking approach | salumi | ANSYS Meshing & Geometry | 9 | November 23, 2016 04:14 |
[ANSYS Meshing] Inflation layers element quality | frossi | ANSYS Meshing & Geometry | 0 | July 2, 2016 20:19 |
Improve the mesh quality | bithnxtlz | FLUENT | 1 | April 30, 2016 12:20 |
[ICEM] How to improve bad quality elements that are obtained after creating prism layers? | Rohith Giridhar | ANSYS Meshing & Geometry | 2 | July 11, 2015 18:04 |
[ICEM] Hex refinement negative quality afterwards | Anorky | ANSYS Meshing & Geometry | 8 | March 22, 2010 03:25 |