|
[Sponsors] |
March 20, 2017, 04:39 |
[Turbogrid]
|
#1 |
New Member
Mmaragann
Join Date: Dec 2016
Posts: 10
Rep Power: 9 |
Hello everyone,
I have a question regarding Turbogrid Version 18. I want to make an inducer mesh with blades that revolve 360 degrees around the hub. There is a very small tip gap with a constant span of 0.995. Turbogrid can't resolve the tip mesh and I get the error that "my mesh is too coarse". I checked all my meshing parameters and I think the parameters are fine enough. However when I try to resolve a tip clearance with a constant span of 0.975 it works very good. So my question is: Does Turbogrid have a limit of how small a tip clearance can be to actually resolve the tip mesh? Thank you all very much! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Turbogrid] TurboGrid Mesh Count | Saima | ANSYS Meshing & Geometry | 0 | February 27, 2014 16:15 |