 |
 |
 |
|
|
|
[Sponsors] | ||||
inlet and outlet condition for a simple model |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 13, 2023, 01:42
|
inlet and outlet condition for a simple model
|
#1 |
|
Member
Jigs
Join Date: Aug 2017
Location: Pune
Posts: 39
Rep Power: 8  |
Hi folks,
It might look weird but i have a doubt on inlet and outlet condition inputs. The scenario is i have 3 inlet where fans are placed having mass flow rate of 0.1 kg/s each and 4 outlet where 4 fans are placed and have same mass flow rate each. How to provide boundary condition? Kindly guide. Thanks |
|
|
|
|
|
September 13, 2023, 16:49
|
|
#2 |
|
Senior Member
Erik
Join Date: Feb 2011
Location: Earth (Land portion)
Posts: 1,171
Rep Power: 23 |
Use mass flow for all except set one outlet set to pressure. The mass flow of that one will of course be set to the remainder by conservation of mass.
|
|
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Inlet & outlet both pressure boundary condition | shouvik ghorui | OpenFOAM | 5 | November 1, 2022 04:39 |
| Table bounds warnings at: END OF TIME STEP | CFXer | CFX | 4 | July 16, 2020 23:44 |
| outlet, opening, inlet boundary condition | namandoshi | CFX | 1 | April 28, 2018 05:52 |
| map outlet boundary profile as an inlet condition using UDF | Daniel_Khazaei | Fluent UDF and Scheme Programming | 2 | June 20, 2016 11:53 |
| steam flow in a pipe driven by a pressure gradient between inlet and outlet | SalvoCalvo | COMSOL | 0 | March 11, 2010 06:52 |
Linear Mode
