[happy]

Hello every member...

Acually, nowdays I have to simulate my 3D system by ANSYS 12 (CFX). However its mishing was not ready to run and get results So I have to create its own mesh to be able to have results. my issue is that I cannot get starting correctly. So I wait your support during next a few hours although I have already practised many tutorials to be perfect..my sys is opened vertical squer channel with slip beside each corner on each single wall and there is heat resource at its centre bottom.Please, could anyone ,please, help me and I will give him/her extra information.
In general, I need some general guidenece like which best code to draw my own mesh and so on

Kind regards.