Phoenics simulation of a wind turbine with and without winglets

Khurram381 · March 27, 2015, 20:35

Hi all,

I'm doing a project on analysis of power generation from a turbine with and without winglets using Phoenics simulation software. I have designed these two turbines on solid works but em struggling for the analysis and simulation on Phoenics.

If any one interested to help me out in this final year project then its much appreciated

Please show up your email addresses for further conversation.

Regards,

Khurram

gupta29505 · March 28, 2015, 19:09

Are you open to using other software - Fluent, CFX, OpenFOAM? If yes, send me an email to freelancer.cfd@gmail.com and I can guide you.

Khurram381 · March 29, 2015, 20:13

thanks for your reply,

at our university, we are being taught CFD by using Phoenics so i'm bound to it. But if you can help me out to calculate the mesh and turbine area in x, y and z coordinate, then it would be great help. i can not generate unstructured mesh on phoenics as it only allows to generate a structured mesh on boundry walls.

March 27, 2015, 20:35	Phoenics simulation of a wind turbine with and without winglets	#1
Khurram381 New Member Khurram Gohar Join Date: Mar 2015 Posts: 10 Rep Power: 11	Hi all, I'm doing a project on analysis of power generation from a turbine with and without winglets using Phoenics simulation software. I have designed these two turbines on solid works but em struggling for the analysis and simulation on Phoenics. If any one interested to help me out in this final year project then its much appreciated Please show up your email addresses for further conversation. Regards, Khurram

March 28, 2015, 19:09		#2
gupta29505 Member freelancer.cae Join Date: Feb 2014 Location: USA Posts: 52 Rep Power: 12	Are you open to using other software - Fluent, CFX, OpenFOAM? If yes, send me an email to freelancer.cfd@gmail.com and I can guide you.

March 29, 2015, 20:13		#3
Khurram381 New Member Khurram Gohar Join Date: Mar 2015 Posts: 10 Rep Power: 11	thanks for your reply, at our university, we are being taught CFD by using Phoenics so i'm bound to it. But if you can help me out to calculate the mesh and turbine area in x, y and z coordinate, then it would be great help. i can not generate unstructured mesh on phoenics as it only allows to generate a structured mesh on boundry walls.