Named Selection Mesh View

mgpaul · October 27, 2015, 16:25

Hello all,

I am trying to view the mesh on the surface of my wing, which is inside my fluid box. I have named all the faces associated with it under named selection. I would like to view the surface mesh of the wing while hiding the mesh of the fluid so I can do some quality checks and edit as I see fit. However, everytime I go to highlight it under named selections, the mesh disappears. When I toggle "show mesh" it shows the mesh of all named selections and I cant see the surface of my wing. (See attached photos.)

Any reason why this is happening? I am using ANSYS v16 and am doing my meshing in the workbench.

gupta29505 · October 27, 2015, 19:23

send me your model at freelancer.cfd@gmail.com and I will fix it and send you back

mgpaul · October 28, 2015, 00:37

As much as I appreciate the reply, I would rather not send an email to somebody I do not know.

Is there no suggestions you can offer me through this thread?

Rakeshvb · October 28, 2015, 08:56

You can use cut planes

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] SnappyHexMesh no layers and no decent mesh for complex geometry	pizzaspinate	OpenFOAM Meshing & Mesh Conversion	1	February 25, 2015 07:05
Meshing Issue with Named Selection	DamR	FLUENT	0	January 1, 2015 03:00
Moving mesh	Niklas Wikstrom (Wikstrom)	OpenFOAM Running, Solving & CFD	122	June 15, 2014 06:20
Problem with compile the setParabolicInlet	ivanyao	OpenFOAM Running, Solving & CFD	6	September 5, 2008 20:50
How to control Minximum mesh space?	hung	FLUENT	7	April 18, 2005 09:38

October 27, 2015, 19:23		#2
gupta29505 Member freelancer.cae Join Date: Feb 2014 Location: USA Posts: 52 Rep Power: 12	send me your model at freelancer.cfd@gmail.com and I will fix it and send you back

October 28, 2015, 00:37		#3
mgpaul New Member Matthew Join Date: Oct 2015 Posts: 8 Rep Power: 10	As much as I appreciate the reply, I would rather not send an email to somebody I do not know. Is there no suggestions you can offer me through this thread?

October 28, 2015, 08:56		#4
Rakeshvb New Member Join Date: Nov 2013 Posts: 3 Rep Power: 12	You can use cut planes