 |
 |
 |
|
|
|
[Sponsors] | ||||
February 7, 2013, 09:25
|
Problem with cfx ERROR #001100279
|
#1 |
|
Senior Member
Talles Caio
Join Date: Oct 2012
Location: Brazil
Posts: 101
Rep Power: 13  |
I'm working on a pipe with knees, and the following issue is being presented in time to run in cfx:
* ERROR # 001100279 has occurred in subroutine ErrAction. * Message: Floating point exception: Overflow when creating the mesh in Icem I refined my knees and part of the next pipe, but the rest I leave the pipe with large elements. this would be the possible cause of the error reported above?? |
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| CFX Mesh Deformation problem | Silmaril | CFX | 7 | October 19, 2010 10:00 |
| CFX Casting problem: Can it be done all in one? | jfasl | CFX | 1 | September 14, 2010 03:14 |
| cfx mesh problem... | mactech001 | ANSYS Meshing & Geometry | 0 | November 5, 2009 02:19 |
| Fan Modelling Problem in CFX | Jenny | CFX | 8 | September 11, 2007 13:59 |
| CFX 4.4 installation problem | Pandu Sattvika | CFX | 1 | December 1, 2001 04:07 |
Threaded Mode
