|
[Sponsors] |
my case in CFX runs in single mode but in parallel it does not |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 16, 2014, 11:47 |
my case in CFX runs in single mode but in parallel it does not
|
#1 |
Senior Member
Przemek
Join Date: Jun 2011
Posts: 249
Rep Power: 15 |
Hi all,
I am doing 3D mixer simulation with radiation. I have two domains (stationary and rotating). I use transient rotor stator interface. My question is why CFX runs on one processor but in the parallel mode (e.g. on 4 processors) solver crashes? If anybody can help? best regards pBlasiak |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Parallel Moving Mesh Bug for Multi-patch Case | albcem | OpenFOAM Bugs | 17 | April 28, 2013 23:44 |
Parallel runs with sonicDyMFoam crashes (works fine with sonicFoam) | jnilsson | OpenFOAM Running, Solving & CFD | 0 | March 9, 2012 06:45 |
CFX Parallel Setup on windows 7 x64 | SlicedBread | CFX | 1 | November 14, 2011 17:06 |
Grid Check Fails in Parallel Processing Mode | askance | Main CFD Forum | 0 | October 20, 2010 10:11 |
parallel mode - small problem? | co2 | FLUENT | 2 | June 1, 2004 23:47 |