|
[Sponsors] |
March 27, 2015, 08:48 |
Cause the high error in my model?
|
#1 |
Senior Member
Hydreaulic structures
Join Date: Sep 2012
Posts: 283
Rep Power: 14 |
hi every one
i run model as shown, I've analyzed within 4 days, finally today finished, unfortunately my result have high error with experimental data, could any one please give me advice i used body sizing with element size=0.5 and soft behavior, then i used inflation that shown red follow(first layer heght=0.1, maximum layer=60) in cfx pre i used k-epsilon turbulence model. my flow as shown follow before spillway and on spillway have wawe , i dont know cause this wave? please help me that you order Where is the problem? i very confused. thanks in advance |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Superlinear speedup in OpenFOAM 13 | msrinath80 | OpenFOAM Running, Solving & CFD | 18 | March 3, 2015 05:36 |
manualInjection model in sprayFoam | Mentalo | OpenFOAM Running, Solving & CFD | 1 | April 2, 2014 09:29 |
Cooling- Heat transfer model | Markat | FLUENT | 9 | February 9, 2013 00:22 |
LES and combustion model | Margherita Cadorin | CFX | 0 | October 29, 2008 05:24 |
High Combustion Temperature in the EBU model | Mehdi | Siemens | 0 | April 24, 2006 05:53 |