|
[Sponsors] |
October 13, 2015, 14:18 |
Convergence criteria
|
#1 |
Senior Member
Anton Kidess
Join Date: May 2009
Location: Germany
Posts: 1,377
Rep Power: 30 |
I'm using CFX together with Ansys workbench. Everything is going nicely, except that the solver stops after one or two iterations even though the solution is not converged yet - if I rerun the case the results change and the residual decreases even further. I've been looking for a while, but I can't seem to find a setting to force the solver to run for a specified number of iterations or tighten the residual criterion. Can anyone point me where to find those settings?
__________________
*On twitter @akidTwit *Spend as much time formulating your questions as you expect people to spend on their answer. |
|
October 13, 2015, 17:40 |
|
#2 |
Senior Member
Hydreaulic structures
Join Date: Sep 2012
Posts: 283
Rep Power: 14 |
dear akidess, you can find convergence criteria in solver control in basic settings tab.
|
|
October 20, 2015, 04:25 |
|
#3 |
Senior Member
Maxim
Join Date: Aug 2015
Location: Germany
Posts: 415
Rep Power: 12 |
||
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
question about convergence criteria in Flow Simulation | drdet | FloEFD, FloWorks & FloTHERM | 2 | January 16, 2015 09:36 |
Time step size & convergence absolute criteria | yuitsang | FLUENT | 5 | April 15, 2013 04:27 |
Force can not converge | colopolo | CFX | 13 | October 4, 2011 22:03 |
What value shall I set for the Convergence criteria? | steventay | CFX | 7 | May 14, 2010 12:44 |
Convergence Criteria | edwin | FLUENT | 1 | February 14, 2008 19:24 |