|
[Sponsors] |
September 10, 2016, 05:05 |
license problem in simulation
|
#1 |
Senior Member
Aja
Join Date: Nov 2013
Posts: 496
Rep Power: 14 |
Hi,
I am running a turbine. When solution reach to about 300-400 iteration, I stop run and then i save. but when i again continue run, i have the following error! Why does this happen? I am grateful that guide me about this case. Best. Aja Last edited by aja1345; September 12, 2016 at 16:06. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem in initializing transient simulation with a finer mesh | sidd | CFX | 8 | April 29, 2016 02:25 |
Contact simulation Problem | nguyenthanhctm | FLUENT | 0 | December 19, 2013 08:21 |
SimpleFoam convergence problem with really simple simulation | mayank.dce2k7 | OpenFOAM Running, Solving & CFD | 2 | November 19, 2013 05:28 |
Low pressure de Laval simulation convergence problem | heksel8i | FLUENT | 3 | July 22, 2013 10:28 |
Heat Transfer simulation: No convergence problem | fiqs | CFX | 2 | April 21, 2010 15:47 |