|
[Sponsors] |
February 13, 2017, 06:41 |
Problem rotating frame of reference.
|
#1 |
New Member
Rocky
Join Date: Jan 2017
Posts: 21
Rep Power: 9 |
Hi All,
CFX solve pop out this error before it starts to run. The angle between the specified velocity and the element surface is| | 43.727 degrees at this face. This is considered an error because | | it implies that the mesh is moving. The following are possible | | reasons for the error message. In the CFX setup, I set my fluid wall to counter rotating wall. It works in cylindrical enclosure but it fail to work in a rectangular enclosure. Anyone can tell me how should I setup? in order to make the rectangular enclosure stay stationary? Fluid Wall |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Second Derivative Zero - Boundary Condition | fu-ki-pa | OpenFOAM | 11 | March 27, 2021 04:28 |
Simple piston movement in cylinder- fluid models | arun1994 | CFX | 4 | July 8, 2016 02:54 |
problem with solving pipe flow in rotating reference frame | rpienika | Main CFD Forum | 0 | March 11, 2016 15:25 |
Different solutions for Rotating Reference Frame | fafou09 | FLUENT | 1 | July 24, 2012 10:06 |
OpenFOAM on MinGW crosscompiler hosted on Linux | allenzhao | OpenFOAM Installation | 127 | January 30, 2009 19:08 |