|
[Sponsors] |
December 1, 2000, 11:26 |
Patch changing along simulation.
|
#1 |
Guest
Posts: n/a
|
Hi everyone,
Is there a way to change the patches along the simulation using CFX? I´m using the 4.3 version and I´m intending to manipulate these patches, say replace a wall with a pressure boundary. I´ve tried USRTPL, but this routine only changes it in the first iteration, not during the simulation. Any suggestion I´d be appreciate. Regards, Fabio. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[CGNS] CGNS converters available | mbeaudoin | OpenFOAM Meshing & Mesh Conversion | 137 | December 14, 2018 04:20 |
[mesh manipulation] CreatePatch | chris1980 | OpenFOAM Meshing & Mesh Conversion | 8 | November 16, 2016 15:44 |
[blockMesh] Cyclic BC's: Possible face ordering problem? (Channel flow) | sega | OpenFOAM Meshing & Mesh Conversion | 3 | September 28, 2010 12:46 |
[Netgen] Create boundary | fabrizio | OpenFOAM Meshing & Mesh Conversion | 1 | October 26, 2008 14:12 |
phase changing simulation | David Liu | Main CFD Forum | 3 | October 25, 2004 01:43 |