Setting a B.C using UserFortran in 4.3

tokai

Hi, Everyone.

I am trying to set a boundary condition of log velocity distribution at inlet. I use USRBCS routine for it and referd the Solver Manual(10.6.2). However error messages come and then solver stops. The messages are:

Solver | runsolve4: Compiling user Fortran...

Solver | f90: Warning: ../fort/zzz000.f, line 185: This statement function has not been used. [IP]

Solver | IP(I,J,K)=IPT((K-1)*ILEN*JLEN+(J-1)*ILEN+I)

Solver | ------^

Solver | f90: Warning: ../fort/zzz001.f, line 185: This statement function has not been used. [IP]

Solver | IP(I,J,K)=IPT((K-1)*ILEN*JLEN+(J-1)*ILEN+I)

Solver | ------^

Solver | f90: Warning: ../fort/zzz002.f, line 185: This statement function has not been used. [IP]

Solver | IP(I,J,K)=IPT((K-1)*ILEN*JLEN+(J-1)*ILEN+I)

Solver | ------^

Solver | runsolve4: Creating executable, please wait...

Solver | ld:

Solver | obj/zzz000.o: usrbcs_: multiply defined

Solver | obj/zzz001.o: usrbcs_: multiply defined

Solver | obj/zzz002.o: usrbcs_: multiply defined

Solver | f77: Severe: Failed while trying to link.

Solver | runsolve4: Failed to link CFX-4.

Solver | runsolve4: Job completed

Solver | An output file was not produced

Solver |

Solver | Finished.

I don't change any parts exept UserArea5. Does anybody give me advice for resolving this problem?

Thanks.