|
[Sponsors] |
April 26, 2017, 06:20 |
tracer test
|
#1 |
Member
Danial
Join Date: Mar 2017
Posts: 40
Rep Power: 9 |
Dear friends, I'm going to do a tracer test in a water channel flow, how can I do it?
is it mentioned in support? thanks. |
|
April 26, 2017, 18:40 |
|
#2 |
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,728
Rep Power: 143 |
Yes, you can do it.
Use an additional variable, set to have convection and diffusion. If you initialise it with a value of zero everywhere and then inject a region with a value of 1.0, you will see it move and spread throughout the flow. |
|
April 27, 2017, 13:04 |
|
#3 |
Member
Danial
Join Date: Mar 2017
Posts: 40
Rep Power: 9 |
could u explain how can I do it?
|
|
April 27, 2017, 18:09 |
|
#4 |
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,728
Rep Power: 143 |
Have a look at the tutorial examples. They are available on the ANSYS customer webpage.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Short shot simulation problems in die casting simulation correlation with test | yanhua.li | FLOW-3D | 12 | August 3, 2016 02:21 |
critical error during installation of openfoam | Fabio88 | OpenFOAM Installation | 21 | June 2, 2010 03:01 |
OF 1.6 | Ubuntu 9.10 (64bit) | GLIBCXX_3.4.11 not found | piprus | OpenFOAM Installation | 22 | February 25, 2010 13:43 |
Tracer Analysis in CFX | Graeme | CFX | 11 | October 25, 2005 10:02 |
Tracer Test on FLUENT | Priyal | Main CFD Forum | 1 | August 27, 1999 11:13 |