Trimmed Surface (CFX5.5) -- CFD Online Discussion Forums

September 18, 2002, 09:29	Trimmed Surface (CFX5.5)	#1
Nelson Guest Posts: n/a	Hi all, I like to create a trimmed surface but there is a warning message as follows, "Loop closure required for trimming. A gap of 0.127649 exists." However, there is no indication in the viewport to show the location of the gap. Anybody knows how to fix this problem? Can I change any setting, eg tolerance, to fix it?? Please help! Thanks! Nelson

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] Problems with coedge curves and surfaces	tommymoose	ANSYS Meshing & Geometry	6	December 1, 2020 11:12
[Gmsh] Error : Self intersecting surface mesh, computing intersections & Error : Impossible	velan	OpenFOAM Meshing & Mesh Conversion	3	October 22, 2015 11:05
[Gmsh] Problem with Gmsh	nishant_hull	OpenFOAM Meshing & Mesh Conversion	23	August 5, 2015 02:09
[Gmsh] boundaries with gmshToFoam‏	ouafa	OpenFOAM Meshing & Mesh Conversion	7	May 21, 2010 12:43
CFX4.3 -build analysis form	Chie Min	CFX	5	July 12, 2001 23:19

All times are GMT -4. The time now is 15:38.