|
[Sponsors] |
September 19, 2002, 08:31 |
axial flow pump, inflow boundary
|
#1 |
Guest
Posts: n/a
|
Hi I use TascFlow to learning cavitation in axial flow pump which is imported blade geometry from CAD application to BladeGen and generated grid by Turbogrid. I have some problem about inflow boundary. When I focus on cavitation, I should set type of boundary as pressure but I when I set pressure to negsative value the solver stop due to error. Who does have an ides to solve this problem. How to calculate pressure at inlet of axial flow pump or estimate it from other parameter. I am looking for other guy who work on cavitatin phenomena or interresting my work for exchange data, blade profile and result. Thank everybody to reading this message. Regards
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Domain Imbalance | HMR | CFX | 5 | October 10, 2016 05:57 |
Periodic boundary conditions in 3D Eulerian granular flow simulations | dsm | FLUENT | 4 | March 2, 2012 19:04 |
CFX does not continue | Shafiul | CFX | 10 | February 17, 2011 07:57 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |
Boundary Layer Flow Paradox | Wen Long | Main CFD Forum | 3 | September 24, 2002 08:47 |