[YOUNS]

Hello

I'm doing analysis for centrifugal compressor.
so Impeller made using bladegen and turbogrid
and Scroll(Volute) made using geometry and mesh.
after there was connected one cfx for analysis and used turbo mode.
Here, however I have a problem.

My warning message is like this.
Cannot create interface between regions Inlet 2(Scroll Inlet) and OUTBlock
OUTFLOW(outlet domain at Impeller, this defined in turbogrid) as they are
not aligned.
This may be caused by an invalid component order. The current
component order is S1, R1, S2, S3.
Please confirm that this is correct before continuing.

I need you guys help.
How to set this to solve this problem.

Have nice day!