|
[Sponsors] |
October 13, 2004, 21:17 |
tascflow:about the mutiple frame reference
|
#1 |
Guest
Posts: n/a
|
Hi,everyone:
I am a beginner of tascflow.I need mutiple frame of reference mode to simulaton a centrifugal pump which includes a rotor and the casing .Now I can generate the grid for the rotor pump.But I don't know how to generate the grids for the spiral casing(I can only run turbogrid ,cfx-build).Then when the grids are generated ,How can I import them to tascflow and attch? The tutorials never tell me what to do.Could you give me any suggestions?Thanks a lot! Regards lingo |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Second Derivative Zero - Boundary Condition | fu-ki-pa | OpenFOAM | 11 | March 27, 2021 04:28 |
Error with Wmake | skabilan | OpenFOAM Installation | 3 | July 28, 2009 00:35 |
OpenFOAM on MinGW crosscompiler hosted on Linux | allenzhao | OpenFOAM Installation | 127 | January 30, 2009 19:08 |
G95 + CGNS | Bruno | Main CFD Forum | 1 | January 30, 2007 00:34 |
Building OpenFoAm on SGI Altix 64bits | anne | OpenFOAM Installation | 8 | June 15, 2006 09:27 |