|
[Sponsors] |
July 4, 2005, 20:17 |
nodes number within boundary layer
|
#1 |
Guest
Posts: n/a
|
Hello,
As discussed in previous posts about SST model, sufficient nodes(5-20) are needed for boundary layer.I was wondering how to DIRECTLY check the nodes number in CFX to make sure that sufficient nodes are provided in boundary layer. In cfx-post? How to do that? Can someone explain this? Thanks! regards! Gab |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] Boundary layer in a pipe | Clementhuon | OpenFOAM Meshing & Mesh Conversion | 6 | March 12, 2012 12:41 |
[GAMBIT] 3D boundary layer and meshing problem in GAMBIT 2.4.6 | prashanthreddyh | ANSYS Meshing & Geometry | 1 | December 20, 2011 00:35 |
[snappyHexMesh] external flow with snappyHexMesh | chelvistero | OpenFOAM Meshing & Mesh Conversion | 11 | January 15, 2010 19:43 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |
Boundary Layer Flow Paradox | Wen Long | Main CFD Forum | 3 | September 24, 2002 08:47 |