 |
 |
 |
|
|
|
[Sponsors] | ||||
February 23, 2019, 02:23
|
Interfaces during sloshing analysis
|
#1 |
|
Member
Aashi
Join Date: Dec 2018
Posts: 43
Rep Power: 7  |
Hello to everyone I am doing sloshing analysis for that i have done meshing by slicing the model to achieve uniform hexahedral/brick meshing after forming it as new part in design modular but when it is opened in cfx setup it has multiple interfaces i defined the interfaces by defining mesh connection after solving the model it is found that fluid found hindrance due to interfaces
Sir kindly guide me why hindrance is there as i already define the connections my geometry is circular |
|
|
|
|
|
February 23, 2019, 03:24
|
|
#2 |
|
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,732
Rep Power: 143 |
Please post an image showing the problem.
__________________
Note: I do not answer CFD questions by PM. CFD questions should be posted on the forum. |
|
|
|
|
|
 |
| Tags |
| cfx |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Medical Image Processing Softwares with CFD Analysis and 3D Printing Capabilities | CornBlitz | Main CFD Forum | 3 | December 15, 2016 05:05 |
| ANSYS WORKBENCH Transfer result of one analysis to a new analysis as preload | ingjuanm90 | ANSYS | 0 | July 26, 2016 14:04 |
| Analysis of rotating fan in room in ansys fluent | harianshu | FLUENT | 0 | April 10, 2016 14:01 |
| Modelling the cross aisle direction of a steel selective rack for model analysis | m8rix | ANSYS | 0 | September 20, 2011 10:28 |
| LES post analysis | faisal_durr | Main CFD Forum | 0 | July 13, 2011 05:52 |
Linear Mode
