|
[Sponsors] |
Modeling of boundary layer wind profile in CFX 5 |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 22, 2005, 09:41 |
Modeling of boundary layer wind profile in CFX 5
|
#1 |
Guest
Posts: n/a
|
I am doing a modeling of a virtual wind tunnel using CFX5 and I try to model the boundary wind layer profile, which follow the either power law or log law. I set a box 2x2m cross section and 3m long and used expression to set the wind speed at inlet as a function of height (let say z coordinate). The result shows the velocity if still uniformly over the cross section.
If any one of you knows how to generate the boundary layer wind profile, please show me some instructions for that. I am highly appreciating your help. Regards, Cuong NK |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Domain Imbalance | HMR | CFX | 5 | October 10, 2016 05:57 |
To thin boundary layer? | Luk | CFX | 3 | February 27, 2009 03:22 |
Ansys CFX Atmospheric Boundary Layer | Marco | CFX | 1 | December 1, 2008 20:46 |
defining velocity profile in a wind tunnel model | Erdem | FLUENT | 0 | June 20, 2006 13:00 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |