|
[Sponsors] |
January 3, 2006, 03:37 |
variant of Tutorial15
|
#1 |
Guest
Posts: n/a
|
Hi,
i will like to run tutorial 15 using a non-newtonian fluid instead of water. i would like to ask a few questions. (1) my fluid changes viscosity with time, do i use a transient or steadystate setup? i notice that under steadystate, i can specificy physical timescale. does this timescale affect my viscosity? (viscosity is keyed in as an expression by myself) (2) i tried using transient, but when running errors surfaced, stating that in transient simulations initialisation value cannot be left blank. i.e. i cannot use AUTOMATIC but have to use AUTOMATIC WITH VALUE. what are the initial values i should key in pertaining to tutorial 15? txs in advance |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
HELP NEEDED with TURBFOAM | dinonettis | OpenFOAM Running, Solving & CFD | 64 | June 22, 2010 09:58 |
BC profile time variant | Alessio | CFX | 0 | February 22, 2008 05:09 |
Problems with variant i208 "Flow around Big Ben" | Alexander | Phoenics | 2 | September 28, 2005 14:14 |