simulation terminates with an error

Sidharthkp · March 3, 2020, 06:15

Hi friends, when i run a simulation using local MPI parallel, it terminates after a few iterations with no output file... This is occuring when i use parallel computation only and also only for this PC(windows 10, Xeon 3.50 GHz with 6 core, 24 GB Ram).

Please give your input on why this is happening.(image attached)

ghorrocks · March 3, 2020, 17:22

If the run starts OK but crashes after a while I would suspect your PC has clagged up with some other application. Maybe a virus checker, maybe another application, maybe your IT department decided to roll out a windows update.

March 3, 2020, 17:22		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,731 Rep Power: 143	If the run starts OK but crashes after a while I would suspect your PC has clagged up with some other application. Maybe a virus checker, maybe another application, maybe your IT department decided to roll out a windows update. __________________ Note: I do not answer CFD questions by PM. CFD questions should be posted on the forum.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[blockMesh] blockMesh with double grading.	spwater	OpenFOAM Meshing & Mesh Conversion	92	January 12, 2019 09:00
Undeclared Identifier Errof UDF	SteveGoat	Fluent UDF and Scheme Programming	7	October 15, 2014 07:11
Version 15 on Mac OS X	gschaider	OpenFOAM Installation	113	December 2, 2009 10:23
Installation OF1.5-dev	ttdtud	OpenFOAM Installation	46	May 5, 2009 02:32
Problem with compile the setParabolicInlet	ivanyao	OpenFOAM Running, Solving & CFD	6	September 5, 2008 20:50