|
[Sponsors] |
October 27, 2006, 08:54 |
ICEM problem
|
#1 |
Guest
Posts: n/a
|
Hi all,
I'm simulating a wind tunnel test for a flow over hydrofoil. After making the mesh, I see mesh elements penetrate the foil with a small hole in the mesh around the foil end. Where is the problem? The foil has a top, bottom and side surfaces. Why the mesh inside the foil not around? Any guides are welcome. Ali |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
ICEM - strange linking problem | RodriguezFatz | ANSYS Meshing & Geometry | 3 | October 25, 2011 03:25 |
[ANSYS Meshing] Problem with Icem Script | Krish | ANSYS Meshing & Geometry | 0 | October 18, 2011 12:10 |
[ICEM] Problem while improting Solidworks Part file or Acis File into ICEM CFD | venki1130 | ANSYS Meshing & Geometry | 0 | October 13, 2011 13:04 |
ICEM boundary condition problem | Martin_D | ANSYS Meshing & Geometry | 2 | February 14, 2011 10:20 |
Icem to FLUENT problem | Babak | FLUENT | 0 | June 10, 2010 17:14 |