|
[Sponsors] |
How to set and control the turbulence in CFX? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 14, 2006, 02:15 |
How to set and control the turbulence in CFX?
|
#1 |
Guest
Posts: n/a
|
I'm making a one stage simulation of steam turbine in CFX. I tried to set different Inlet boundary turbulence condition such as intensity, viscosity, etc. But the results seem no difference in inlet and outlet parameters like pressure, temperature, enthalpy, entropy, etc. Thus leading to the same efficiency.
Does anybody know how to control the turbulence? Thanks above! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
CFX convergence problem simulating ogive-cylinders at varied angle of attack | jdacosta | CFX | 6 | February 25, 2015 21:42 |
[ICEM] How to set bocos on 2D model for ANSYS CFX (tuts no help) | RossFS | ANSYS Meshing & Geometry | 4 | May 22, 2012 08:56 |
How to show the transient case? | H.P.LIU | Phoenics | 7 | July 13, 2010 04:31 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |
How to set the transitional turbulence for blades | Hermann | CFX | 3 | January 5, 2006 14:06 |