|
[Sponsors] |
May 16, 2007, 13:08 |
domain interface
|
#1 |
Guest
Posts: n/a
|
Dear Diego, i want to simulate fluid flow in side channel fuel pump by ansys cfx. this pump have to groove on housing and a impeller. where is suitable for domain interface? for example impeller surface or groov surface or impeller surface+NUMBER ?
Best regard |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
CFX does not continue | Shafiul | CFX | 10 | February 17, 2011 07:57 |
Interface w. Pitch Change: | Thcfd | CFX | 0 | December 22, 2010 03:50 |
increasing mesh quality is leading to poor convergence | tippo | CFX | 2 | May 5, 2009 10:55 |
No results for solid domain | Gary Holland | CFX | 10 | March 13, 2009 03:30 |
Fluid - Solid Domain Interface | Daniel | CFX | 6 | February 15, 2009 18:09 |