|
[Sponsors] |
September 5, 2007, 11:29 |
ICEM vs Solver
|
#1 |
Guest
Posts: n/a
|
As the solver runs through, it will tell you the three main mesh constraints (aspect ratio, etc.). As I make a mesh in ICEM, I try to keep an eye on these topics to make sure I'm not making a monster that won't converge. Recently, I noticed that ICEM will say my max aspect ratio is around 76 or so. The solver says its around 618. This is kind of confusing to me. Am I missing something blatant? Am I not setting something up right?
-W |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
PEM Fuel cell module meshes. ICEM vs workbench | aarvay | FLUENT | 24 | March 2, 2020 06:50 |
Help for constructing an Unstructured Incompressible solver | moomba | Main CFD Forum | 0 | February 25, 2010 15:38 |
Design Modeler to ICEM..... | Joe | CFX | 0 | January 24, 2008 03:39 |
Symmetry plane error in solver | Santiago Orrego. | CFX | 6 | January 31, 2007 07:09 |
Icem - solver | Jones | CFX | 3 | October 19, 2006 05:39 |