|
[Sponsors] |
February 20, 2023, 05:15 |
heat transfer through gap
|
#1 |
New Member
Hossein Sheykh
Join Date: Jan 2023
Posts: 6
Rep Power: 3 |
Hello,
I am simulating a heat exchanger based on the TPMS core. I created the geometry on nTopology platform and transferred it to CFX for simulation. But CFX cannot distinguish between the interfaces, so I had to delete the solid which left a gap between hot and cold fluid. When I run the simulation in this way, no heat transfer occurs, although it converges. I use the mass flow rate and temperature of inlets to find the outlet temperatures and pressures. Any idea if there is any way to overcome the issue? Many thanks Hossein |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Interphase mass transfer of a reaction | cfx_ws1992 | Main CFD Forum | 0 | May 15, 2017 21:42 |
CFD simulation and heat transfer of gap flow in rectangular duct | marv91 | OpenFOAM Running, Solving & CFD | 0 | April 17, 2017 09:11 |
Heat transfer through gap in CFX? | shivasluzz | CFX | 4 | September 3, 2014 12:32 |
Radiation interface | hinca | CFX | 15 | January 26, 2014 17:11 |
Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 03:32 |