|
[Sponsors] |
December 13, 2007, 02:22 |
how to apply VOF in a tank???
|
#1 |
Guest
Posts: n/a
|
hello
i am trying to create a transient analysis of a tank that has 50% water and 50% air and a rotation of the tank about 30 decreas. and i would like to see only the surface of the water and how it is sloshing. i create the mesh (a cyllinder) and also read the tutorial but i have some question.... 1) can i give all surfaces as a wall??? the tutorial describes only with inlet and outlets. 2) how to apply vof ? as the tutorial but i should change the high? 3) and last one ... any idea/??? best regards hayate |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
VOF or not for sloshing of a full tank? | Brian | FLUENT | 3 | August 17, 2011 06:35 |
How to apply VOF method? | yeeking86 | CFX | 7 | August 23, 2010 18:24 |
Mass conservation problem in mixing tank multiphase simulation | rockewan | FLUENT | 0 | April 6, 2010 12:34 |
apply vof module to a gas bubble in water | mekhan | CFX | 1 | September 30, 2009 19:34 |
vof tank emptying | star123 | FLUENT | 7 | January 26, 2006 05:14 |