|
[Sponsors] |
July 15, 2023, 13:11 |
Floatation point error
|
#1 |
New Member
Bhanu Swaroop Madiraju
Join Date: May 2023
Posts: 10
Rep Power: 3 |
Hi,
I am trying to run a simulation for a centrifugal compressor with co2 (initial pressure of 65 bar and pressure ratio is 2). I am getting the finmes error, the solution is diverging. So I went through the steps mentioned in best practices guide. First I tried to get the initial condition using physical timescale and upwind condition for first order numerics. I tried a iterative process for the timescale from 1e-6 to 1e-9 but still faced the same issue. I tried using local timescale and then change to physical timescale once the solution is steadying but even that failed after a few iterations. The mesh quality is good. The boundary conditions are correct (I ran a similar compressor but for initial pressure of 33.7 bar and pressure ratio 2, the solution converged with the boundary setup). So could anyone help with the issue? (The gas is in vapor phase). |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Building OpenFOAM1.7.0 from source | ata | OpenFOAM Installation | 46 | March 6, 2022 13:21 |
long error when using make-install SU2_AD. | tomp1993 | SU2 Installation | 3 | March 17, 2018 06:25 |
DPM udf error | haghshenasfard | FLUENT | 0 | April 13, 2016 06:35 |
Ansys Fluent 13.0 UDF compilation problem in Window XP (32 bit) | Yogini | Fluent UDF and Scheme Programming | 7 | October 3, 2012 07:24 |
user subroutine error | CFDUSER | CFX | 2 | December 9, 2006 06:31 |